Your advantages

• Space-saving installation
• Easy-to-install thanks to low weight and large scope of delivery
• Flexible due to free selection of inlets
• Operationally reliable with integrated thermic motor protection and mains-independent alarm

Construction

Sewage lifting unit as single pump system or double-pump system

Application

Pumping of sewage containing faeces (according to DIN EN 12050-1) that cannot be returned to the sewer system using natural falls, and backflow resistant drainage of discharge points below the backflow level (according to DIN EN 12056-1).

Equipment/function

• Ready-to-plug
• Thermal motor monitoring
• Level control with float switch
• Mains-independent alarm
• Potential-free contact
• Pump cable detachable
• Non-return valve (RV version)
• Inlet seal
• Hole saw for inlet borehole
• Hose connection for ventilation
• Seal for suction pipe connection for diaphragm hand pump
• Kit for pressure pipe connection
• Fixation material
• Soundproofing material
• Switchgear

Scope of delivery

Connection-ready sewage lifting unit, including:

• Switchgear with mains-independent alarm and plug:
• 1x inlet seal DN 100
• 1x hole saw for inlet DN 100
• 1x lip seal for connection of diaphragm hand pump or inlet connection Ø 50 mm
• 1x collar for ventilation connection DN 70
• 1x flange connector DN 80/100 with flat gasket, flexible hose section and fixing material for discharge pipe connection DN 100
• 1x DN 80 non-return valve (only for M1/8RV and M2/8)
• Sound absorption strips for sound insulation installation
• 9 V rechargeable battery
• Fixation material
• Installation and operating instructions

Type key

Technical data

• Mains connection 1~230 V, 50 Hz or 3~400 V, 50 Hz
• Power consumption P1 = 1.3 kW
• Cable length from system to switchgear 4 m / plug cable 1.5 m
• Operating mode S3-15%, 80 sec
• Fluid temperature max. 40 °C, for short periods (3 min.) 60 °C
• Max. ambient temperature of 40 °C
• Free ball passage 45 mm
• Pressure port DN 80
• Inlet connection DN 40 / DN 100 / DN 150
• Ventilation connection DN 70
• Min. suction head (installation level to middle of inlet) 180 mm
• Protection class (without switchgear) IP 67
• Gross tank volume 62 l to 115 l, depending on type
• Switching volume 24 l to 40 l, depending on type

Materials

• Motor housing: Stainless steel 1.4301
• Hydraulic housing: Cast iron EN-GJL-250
• Impeller: PUR plastic
• Tank: PE plastic

Description/construction

Fully submersible sewage lifting unit, ready for connection (flooding height: 2 mWS, overflow time: 7 days) with a gas and watertight collection tank equipped with buoyancy safeguards. Centrifugal pump with vortex impeller.

DrainLift M1/8:

Single-pump system with single-phase or three-phase AC motor for automatic operation. Switchgear with shock-proof or CEE plug, potential-free contact, integrated and mains-independent alarm and adjustable follow-up time.

RV version with non-return valve included in the scope of delivery.

DrainLift M2/8:

Double-pump system for automatic operation (with automatic duty cycling, standby and peak-load operation). Due to the integrated double non-return valve, only one pressure pipe connection is required. Switchgear with shock-proof or CEE plug, potential-free contact, maintenance interval display, early fault detection and integrated and mains-independent alarm and adjustable follow-up time.

Attention: The switchgear is not submersible and must therefore be arranged in such a way that it is overflow-proof.