Compact lifting unit with alarm contact, ready for connection, for wash basin, shower, bathtub and condensing boiler drainage.

Fluid

For collection and pumping of the following in domestic areas:

• Sewage not containing faeces
• Condensate (as of pH value 2.5) – not in pure form, but rather mixed with sewage from another inlet.

Sewage pumping according to 12050

The sewage lifting unit meets the requirements of EN 12050-2.

Construction

Compact lifting unit with submersible pump, ready for connection. Level measurement performed by a level sensor. Venting is integrated in the inner cover and equipped with an active carbon filter. The lifting unit is also equipped with a buzzer and a potential-free alarm contact (max switching capacity: 42 V=, 500 mA, contact type: normally closed contact (NC)). If there is high water in the tank, an alarm sounds by means of the buzzer. An external alarm signal can also be connected via the potential-free contact. The tank lid seals the unit perfectly.

Up to four connections are available:

• 1x 40 mm inlet (DN 40) without non-return valve, located on top, closed ex-works.
• 2x 40/50 mm inlets (DN 40/50) with non-return valve, horizontal position on left and right side, open ex-works.
• 1x 32/40 mm discharge port (DN 32/40) with non-return valve, located on top, open ex-works. If necessary, the discharge port can be positioned horizontally on the right side. The associated opening is closed ex-works.

Scope of delivery

• 1x collar for HT pipe DN 32/40 (32/40 mm)
• 2x 32–50 mm hose clips
• 2x inlet connections DN 50 (50 mm)
• 2x collars for HT pipe DN 40/50 (40/50 mm)
• 2x non-return valve
• 2x 50–70 mm pipe clamps
• 2x 32–50 mm hose clips
• 2x sealing plug
• 6x O-rings
• Install floor fixation (buoyancy safeguards): 2x mounting brackets with screws and wall plugs
• Kit for emergency drainage (drainage hose, hose clip, sealing plug)
• Kit for depth suction
• Kit for horizontal discharge port
• Installation and operating instructions