Yonos GIGA-N 65/125-5,5/2-P5-R1

Single-stage centrifugal pump as baseplate pump in accordance with EN 733, with axial suction ports and radial pressure ports for installation on a base. Pump with support foot and flanged bearing bracket, coupling, coupling guard and motor mounted to same baseplate.

IEC motor with 3 PTC thermistor sensors. Shaft sealing with bidirectional bellows mechanical seal. Grey cast iron housing, stainless steel shaft, grey cast iron impeller. Cataphoretic coating as standard for all cast iron components in contact with fluid.

With integrated frequency converter for an electronic control for constant differential pressure (Δp-c) and others.

Construction

• Single-stage low-pressure centrifugal pump
• Spiral housing with flange and housing dimensions according to DIN EN 733, flanges PN 16 – according to EN 1092-2
• Pump housing and discharge cover with cataphoretic coating as standard
• Direction-of-rotation-independent bellows mechanical seal with forced flushing and cavitation-reducing impeller.
• Mechanical seal for water feed up to T=140 °C; up to Tmax= +40 °C a glycol admixture of 20 to 40 % by vol. is permitted

Coupling variants:

• Spacer coupling (standard)
• Elastic coupling (variant P5, at a reduced price)

Impeller variants (for an additional charge):

• Bronze
• Stainless steel

NOTICE

The elastic coupling does not contain a spacer.

The spacer coupling is an elastic coupling with a spacer. The spacer reduces maintenance costs, and further motor orientation when changing the mechanical seal is not necessary.

Standard equipment

Pump display for displaying:

• Δp-c control mode (constant differential pressure), PID control, n-constant (constant speed)
• Setpoint (e.g. differential pressure or speed)
• Error and warning messages
• Actual values (e.g. power consumption, actual value of the sensor)
• Operating data (e.g. operating hours, energy consumption)
• Status data (e.g. status of SSM and SBM relay)
• Device data (e.g. pump name)
• Operating mode (for Y-piece installation only: main/standby operation, parallel operation)

One-button manual operation level for:

• Pump On/Off
• Setpoint and speed adjustment
• Selecting the operation and control mode
• Configuration of operating parameters
• Fault acknowledgement

Additional functions

• Interfaces: Control input "Overriding Off", analogue input 0–10 V, 2–10 V, 0–20 mA, 4–20 mA for manual control mode (DDC) or for remote setpoint adjustment, IR interface for wireless communication with operating and service unit Wilo-IR-Monitor/IR-Stick, plug-in slot for Wilo IF-modules for connecting to building automation, configurable, potential-free fault and run signal
• Integrated double pump management for Y-pipe installation
• Integrated full motor protection (PTC thermistor sensor) with trip electronics
• Different operating modes for heating mode or air-conditioning mode
• Access disable on the pump
• Different operation levels: Standard / Service

Accessories

• IR-Stick
• IF module PLR
• IF module LON
• IF module Modbus
• IF module BACnet
• IF module CAN
• Differential pressure sensor (DDG) sets 0-10 V for pumps in version ...-R1