Wilo-DrainLift MINI5

Compact lifting unit with alarm contact, ready for connection, for wash basin, shower, bathtub, WC and condensing boiler drainage.

For installation in rooms or as a concealed-wall installation. To be connected to the following drainage fixtures:

DrainLift MINI5-XS/C

• Wash basin
• Shower
• Bathtub
• Dishwasher
• Washing machine
• Condensing boiler

DrainLift MINI5-XS/WC

• Bathroom/toilet
• Wash basin
• Shower

DrainLift MINI5-XS/C

For collection and pumping of the following in domestic areas:

• Sewage not containing faeces
• Condensate (as of pH value 2.5) – not in pure form, but rather mixed with sewage from another inlet.

Sewage pumping according to 12050

The sewage lifting unit meets the requirements of EN 12050-2.

DrainLift MINI5-XS/WC

For collection and pumping of the following in domestic areas:

• Sewage containing faeces

Sewage pumping according to 12050

The sewage lifting unit meets the requirements of EN 12050-3.

• Ready-to-plug
• Level measurement with level sensor
• Vertical discharge port; can be converted to horizontal discharge port.
• At most three inlets
• “WC” version with toilet connection
• Venting with active carbon filter
• “Silent mode” (DrainLift MINI5-XS/C only)
• Depth suction
• Alarm signal (buzzer) with potential-free contact

• Mains connection: 1~230 V, 50 Hz
• Operating mode: S3 15%
• Fluid temperature: 3 to 50 °C (37 to 122 °F), max. 75 °C (167 °F) for 30 minutes
• Ambient temperature max.: 3 to 40 °C (37 to 104 °F)
• Protection class: IP44

Wilo-DrainLift MINI5-XS/C

Compact lifting unit with submersible pump, ready for connection. Level measurement performed by a level sensor. Venting is integrated in the inner cover and equipped with an active carbon filter. The lifting unit is also equipped with a buzzer and a potential-free alarm contact (max switching capacity: 42 V=, 500 mA, contact type: normally closed contact (NC)). If there is high water in the tank, an alarm sounds by means of the buzzer. An external alarm signal can also be connected via the potential-free contact. The tank lid seals the unit perfectly.

Up to four connections are available:

• 1x 40 mm inlet (DN 40) without non-return valve, located on top, closed ex-works.
• 2x 40/50 mm inlets (DN 40/50) with non-return valve, horizontal position on left and right side, open ex-works.
• 1x 32/40 mm discharge port (DN 32/40) with non-return valve, located on top, open ex-works. If necessary, the discharge port can be positioned horizontally on the right side. The associated opening is closed ex-works.

Wilo-DrainLift MINI5-XS/WC

Compact, fully submersible lifting unit with submersible pump, ready for connection. The submersible pump is equipped with a rotating blade. The blade reliably shreds faeces in sewage. Level measurement performed by a level sensor. Venting is integrated in the inner cover and equipped with an active carbon filter. The lifting unit is also equipped with a buzzer and a potential-free alarm contact (max switching capacity: 42 V=, 500 mA, contact type: normally closed contact (NC)). If there is high water in the tank, an alarm sounds by means of the buzzer. An external alarm signal can also be connected via the potential-free contact. The tank lid seals the unit perfectly.

Up to five connections are available:

• 1x 40 mm inlet (DN 40) without non-return valve, located on top, closed ex-works.
• 2x 40/50 mm inlets (DN 40/50) with non-return valve, horizontal position on left and right side, open ex-works.
• 1x 110 mm toilet connection (DN 110), located in front, open ex-works. If necessary, the WC connection can be positioned horizontally on the left side. The associated opening is closed ex-works.
• 1x 32/40 mm discharge port (DN 32/40) with non-return valve, located on top, open ex-works. If necessary, the discharge port can be positioned horizontally on the right side. The associated opening is closed ex-works.

Discharge port

• 1x collar for HT pipe DN 32/40 (32/40 mm)
• 2x 32–50 mm hose clips

Toilet connection (WC version only)

• 1x collar for HT pipe DN 110 (110 mm)
• 1x clamp ring
• 1x 110-130 mm hose clip

Inlet connection

• 2x inlet connections DN 50 (50 mm)
• 2x collars for HT pipe DN 40/50 (40/50 mm)
• 2x non-return valve
• 2x 50–70 mm pipe clamps
• 2x 32–50 mm hose clips
• 2x sealing plug
• 6x O-rings

General

• Install floor fixation (buoyancy safeguards): 2x mounting brackets with screws and wall plugs
• Kit for emergency drainage (drainage hose, hose clip, sealing plug)
• Kit for horizontal discharge port
• Installation and operating instructions

• Ready-to-plug
• Level measurement with level sensor
• Vertical discharge port; can be converted to horizontal discharge port.
• At most three inlets
• “WC” version with toilet connection
• Venting with active carbon filter
• “Silent mode” (DrainLift MINI5-XS/C only)
• Depth suction
• Alarm signal (buzzer) with potential-free contact

• Mains connection: 1~230 V, 50 Hz
• Operating mode: S3 15%
• Fluid temperature: 3 to 50 °C (37 to 122 °F), max. 75 °C (167 °F) for 30 minutes
• Ambient temperature max.: 3 to 40 °C (37 to 104 °F)
• Protection class: IP44

Wilo-DrainLift MINI5-XS/C

Compact lifting unit with submersible pump, ready for connection. Level measurement performed by a level sensor. Venting is integrated in the inner cover and equipped with an active carbon filter. The lifting unit is also equipped with a buzzer and a potential-free alarm contact (max switching capacity: 42 V=, 500 mA, contact type: normally closed contact (NC)). If there is high water in the tank, an alarm sounds by means of the buzzer. An external alarm signal can also be connected via the potential-free contact. The tank lid seals the unit perfectly.

Up to four connections are available:

• 1x 40 mm inlet (DN 40) without non-return valve, located on top, closed ex-works.
• 2x 40/50 mm inlets (DN 40/50) with non-return valve, horizontal position on left and right side, open ex-works.
• 1x 32/40 mm discharge port (DN 32/40) with non-return valve, located on top, open ex-works. If necessary, the discharge port can be positioned horizontally on the right side. The associated opening is closed ex-works.

Wilo-DrainLift MINI5-XS/WC

Compact, fully submersible lifting unit with submersible pump, ready for connection. The submersible pump is equipped with a rotating blade. The blade reliably shreds faeces in sewage. Level measurement performed by a level sensor. Venting is integrated in the inner cover and equipped with an active carbon filter. The lifting unit is also equipped with a buzzer and a potential-free alarm contact (max switching capacity: 42 V=, 500 mA, contact type: normally closed contact (NC)). If there is high water in the tank, an alarm sounds by means of the buzzer. An external alarm signal can also be connected via the potential-free contact. The tank lid seals the unit perfectly.

Up to five connections are available:

• 1x 40 mm inlet (DN 40) without non-return valve, located on top, closed ex-works.
• 2x 40/50 mm inlets (DN 40/50) with non-return valve, horizontal position on left and right side, open ex-works.
• 1x 110 mm toilet connection (DN 110), located in front, open ex-works. If necessary, the WC connection can be positioned horizontally on the left side. The associated opening is closed ex-works.
• 1x 32/40 mm discharge port (DN 32/40) with non-return valve, located on top, open ex-works. If necessary, the discharge port can be positioned horizontally on the right side. The associated opening is closed ex-works.

Discharge port

• 1x collar for HT pipe DN 32/40 (32/40 mm)
• 2x 32–50 mm hose clips

Toilet connection (WC version only)

• 1x collar for HT pipe DN 110 (110 mm)
• 1x clamp ring
• 1x 110-130 mm hose clip

Inlet connection

• 2x inlet connections DN 50 (50 mm)
• 2x collars for HT pipe DN 40/50 (40/50 mm)
• 2x non-return valve
• 2x 50–70 mm pipe clamps
• 2x 32–50 mm hose clips
• 2x sealing plug
• 6x O-rings

General

• Install floor fixation (buoyancy safeguards): 2x mounting brackets with screws and wall plugs
• Kit for emergency drainage (drainage hose, hose clip, sealing plug)
• Kit for horizontal discharge port
• Installation and operating instructions