Electronic control and regulation accessories. The Wilo-HiControl 1 series is used for borehole pumps to enable automatic operation. Wilo-HiControl 1 protects the pump against operation with a low volume flow. The volume flow sensor and pressure sensor enable Wilo-HiControl 1 to automate the pump between two values: the start-up pressure and the switch-off volume flow. If the pressure in the network is lower than the start-up pressure, Wilo-HiControl 1 starts the pump. The pump continues to operate until the volume flow falls below the value of the switch-off volume flow.

The small internal tank prevents water hammer and cycling.

Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible pumps for domestic water supply.

Special features

• Simple installation
• Especially compact design makes it suitable for many types of installation locations
• High operational reliability due to electronic fault signal
• Protection of the connected pumps due to built-in protection against low water levels
• Simple operation due to clear operating state display and manometer
• No additional diaphragm pressure vessel required
• Perfect corrosion protection, due to rust-free materials

Inline version with input and output in vertical axis and uniform thread connections, suitable for direct connection to the pump housing or wall surface installation with a wall bracket (accessories).

Notice

The HiControl 1 may be installed only in vertical position with the output at the top!

Scope of delivery

• HiControl 1
• Cable ties for quick and safe installation of ready-to-plug pump units