Search
Contact
E-mail
Catalogue creation
My favorites
Product comparison
Wilo-EMU KPR | Wilo
Your advantages
Wilo-EMU KPR

Your advantages

  • Can be directly installed in the discharge pipe
  • Angle of propeller blades is adjustable
  • Process reliability thanks to comprehensive monitoring devices
  • Low vibration and long service life thanks to high-quality components
  • Individually configurable to match your exact requirements

Recommended services

Series description
Wilo-EMU KPR

Design

Axial pump submersible without cooling system for continuous duty in pipe chambers in the stationary wet well installation.

Application

Pumping of

  • Pre-cleaned sewage without faeces and long-fibre components
  • Process water
  • Wastewater
  • Process water

Equipment/function

  • Heavy-duty version made of grey cast iron

Typekey

NO VALUE

Technical data

  • Mains connection: 3~400 V, 50 Hz
  • Submerged operating mode: S1
  • Protection class: IP68
  • Max. fluid temperature: 3 - 40°C; higher temperatures on request
  • Free ball passage: 85 – 130 mm.
  • Permanently lubricated roller bearings
  • Max. immersion depth: 20 m

Materials

  • Housing components: EN-GJL
  • Propellers: Stainless steel
  • Sealing on pump side: SiC/SiC
  • Sealing on motor side: SiC/SiC
  • Static gaskets: NBR
  • Shaft: Stainless steel 1.4021

Construction

Axial submersible pump as submersible monobloc unit for stationary wet installation

Hydraulics

The angle of the propeller/impeller blades can be adjusted by hand. This makes it possible to adapt the unit to use in different conditions.

Motor

Surface-cooled motors (T motors) give off their heat directly to the surrounding fluid via the housing components and can be used in immersed state for continuous duty.

A sealing chamber protects the motor from fluid ingress. It can be accessed from the outside and can be monitored with an optionally sealing chamber electrode.

All filling fluids used are potentially biodegradable and environmentally safe.

The cable inlet of the T motors is longitudinally watertight. Cable lengths can be individually configured.

Seal

Fluid-side and motor-side sealing is possible in the following versions depending on the motor type:

  • Version G: Two independently-acting mechanical seals
  • Version K: Block seal cartridge with two independently acting mechanical seals

Scope of delivery

  • Axial submersible pump
  • Cable length as per customer request
  • Accessories according to customer request
  • Operating and maintenance manual

Options

  • Special voltages
  • PTC thermistor sensor
  • Internal or external sealing chamber monitoring
  • Monitoring units for leakage and bearing temperature
  • Ceram coating C0, C1
  • Ex-rated according to ATEX or FM

Accessories

  • Switchgear, relays and plugs

Commissioning

Operation with non-immersed motor:

Surface-cooled motors (T motors) can be non-immersed only if an operating mode is specified for non-immersed operation!

Dry-running protection system:

The hydraulics housing must always be immersed to prevent air from being drawn in. In the case of fluctuating fluid levels, the system should shut down automatically once the minimum water submersion is reached.

Documents

Installation and operating instructions

Wilo-EMU KPR

Article Number 6097571
Edition 2007-05
Number of pages 64
Language en
PDF (905 KB)

Certification booklet

Wilo-EMU KPR

Article Number 6080668
Edition 1702
Number of pages 8
Language language neutral
PDF (374 KB)

Group Statement

Group Statement REACH

Edition 2021-05
Number of pages 5
Language language neutral
PDF (279 KB)