DrainLift SANI-M.16/T540/4C-CEE

Ready for connection and fully submersible single-pump lifting unit for pumping aggressive fluids.

Fluid

For the collection and pumping of these fluids in commercial areas:

• Sewage with faeces
• Condensate from boilers
• Lake water and sea water
  Max. NaCl content (salt water): 30 g/l until 20 °C
• Swimming pool water, max. chloride content: 400 mg/l
• Wastewater, slightly acidic with a pH value >3.5
• Demineralised/cleaned water

Sewage pumping according to 12050

The lifting unit follows DIN EN 12050-1.

Construction

Gas- and watertight collection tank:

• Sloped floor at an angle
• Inspection opening with transparent cover
• Freely selectable inlets in the shown areas
• Level measurement with a level sensor 4 ... 20 mA

Sewage pump:

• Mounted directly on the collection tank
• Self-cooling motor (sheath flow cooling) with thermal motor monitoring
• Discharge port with non-return valve including inspection opening attached

Pre-wired "Control EC-L" switchgear for automatic operation:

• Operation through display and icon-based, alphanumeric menu
• Collective fault signal with potential-free contact
• Individual fault signal with potential-free contact
• ModBus interface
• Integrated and mains-independent alarm
• Adjustable follow-up time

Scope of delivery

• Lifting unit with switchgear and connection cable with plug
• Flange connector from DN 80, PN 10 to DN/OD 110
• Flexible collar DN/OD 110 for discharge connection
• HT double socket DN/OD 75 for ventilation connection
• HT double socket DN/OD 50 for drain connection
• Inlet set with hole saw 124 mm (5 in) and seal for HT pipe DN/OD 110
• Floor fixation set
• Noise insulation mat
• 9 V rechargeable battery
• Installation and operating instructions